Snapper Ignition Switches
Snapper ignition switches control electrical circuits enabling engine starting and shutdown on ride-on and zero-turn equipment. Our ignition switch inventory includes Snapper mower ignition switches, starter ignition switches, key switches, and replacement ignition switches for TimeCutter, Z Master, and commercial Snapper models. Snapper Spares stocks Snapper ignition switch assemblies in stock with correct terminal configurations for all major model series, providing worldwide shipping on all ignition switch orders. These essential key switch components route battery power through safety interlocks to starter solenoids and fuel shut-off solenoids whilst providing convenient operator control of mower electrical systems.
Available Snapper Ignition Switches
Ignition Switch Assembly
7018816YP
Snapper
£25.30
In Stock
Ignition Switch Assembly
421064MA
Snapper
£24.64
In Stock
Ignition Switch
7073797YP
Snapper
£21.57
In Stock
Ignition Switch Assembly
1686734SM
Snapper
£29.66
In Stock
Switch Bagger
1001845MA
Snapper
£12.00
In Stock
Clutch/Deck Interlock Switch
7018524YP
Snapper
£15.19
In Stock
Seat Switch
1714771SM
Snapper
£11.42
In Stock
Switch Rmo Module
1761897YP
Snapper
£20.25
In Stock
Push Button Switch
1720411SM
Snapper
£8.85
In Stock
Foot Pedal Switch
7022886YP
Snapper
£9.69
In Stock
Nut, Ignition Switch
720889
Snapper
--
View More
Wiring Harness (For Trombetta Ignition Switch)
1753020YP
Snapper
--
View More
Frequently Asked Questions
How do I test a Snapper ignition switch?
Test ignition switches using a multimeter set to continuity mode, checking that circuits close between proper terminals in each key position (off, run, start). Replace switches showing no continuity or incorrect terminal connections.
Why won't my Snapper start even with the key turned?
Non-starting with key turned indicates faulty ignition switch contacts, corroded switch terminals, or disconnected wiring harness behind the switch. Check for 12V at switch output terminals when key is in start position.
Can I bypass a Snapper ignition switch?
Bypassing ignition switches removes critical safety interlocks and isn't recommended; however, temporary jumper wires between switch terminals can diagnose switch failures. Replace faulty switches rather than permanently bypassing safety systems.
What causes Snapper ignition switches to fail?
Ignition switch failures result from corrosion on brass contacts, worn internal components from repeated cycling, moisture penetration into switch housing, or loose mounting allowing excessive vibration. Plastic switches are particularly prone to contact wear.
Do Snapper ignition switches include safety circuits?
Yes, Snapper ignition switches integrate with safety interlock systems preventing starting unless seat, brake, and PTO switches show proper positions. Faulty ignition switches can prevent starting even when all safety switches function correctly.